S-Type Lanner

Guide as PDF

Download this guide as pdf here.

Welcome to the SCION world! In this guide, you find the initial connection instructions for the Anapaya S-type device. Once the device is unpacked and installed in the technical environment, proceed with the following steps on the Rear Panel:

1. Connect the RJ45 cable to the termination point of the WAN access on port 3.
2. Connect the RJ45 cable to the LAN on port 5.
3. Plug the power supply DC.
4. Turn the device on by pressing the power button P.

note

Your support may indicate other ports to connect the RJ45 cables to.

After a few minutes, the LEDs on the front panel should have the following statuses:

1. System should be solid green.
2. Power should be solid green.
3. The LED 3/4 represents the WAN port(s). The link status of the port 3 should be blinking amber.
4. The LED 5/6/7/8 represents the LAN port(s). The link status of the port 5 should be blinking amber.

note

If the IP addresses has not been assigned automatically using DHCP:

1. Connect a serial cable to the console port (C on the first picture).
2. Connect to the serial console using a baud rate of 115200. Authenticate to the appliance using the default credentials, login: anapaya and password: anapaya.
3. Alternatively port 8 is statically assigned 169.254.1.1/30, and by connecting a computer with a static IP address in the same subnet i.e. 169.254.1.2/30, you can SSH to the appliance using the default credentials.
4. Once logged in, you can setup the WAN IP parameters as indicated by your support. For more information consult Anapaya documentation.
5. DHCP will be active on all ports, and port 8 will be assigned 169.254.1.1/30 until an appliance configuration is applied.

The possible statuses of the RJ45 network LEDs (3 to 8)

LED indicator	Status	Description
Upper LED (speed)	Solid green	Operating as a FastEthernet connection (100 Mbps)
	Solid amber	Operating as a GigaEthernet connection (1’000 Mbps)
	Off	No link has been established
Lower LED (link status)	Solid amber	Link has been established and there is no activity on this port
	Blinking amber	Link has been established and there is activity on this port
	Off	No link has been established

Interface mapping

Interface Name	Port Nr. on device	Port usage	Port type
enp2s0f0	1	Unassigned	Fiber – SFP 1G
enp2s0f1	2	Unassigned	Fiber – SFP 1G
enp2s0f2	3	Default WAN interface	RJ45 – 1000BaseT
enp2s0f3	4	Unassigned	RJ45 – 1000BaseT
enp10s0f0	7	Unassigned	RJ45 – 1000BaseT
enp10s0f1	8	Unassigned	RJ45 – 1000BaseT
enp8s0f0	5	Default LAN interface	RJ45 – 1000BaseT
enp8s0f1	6	Unassigned	RJ45 – 1000BaseT

The official manual of the S-type hardware (Lanner L-1515 4C) is available at https://www.whiteboxsolution.com/product/l-1515/.